|These strong steel cables prevent hose whip in case of accidental separation of coupling or clamp device. The King Cable reaches across the hose fittings to provide standby safety for hose. Spring-loaded loops in the cable ends open easily to pass over the couplings for a firm grip on the hose. These cables are thoroughly tested with years of service. They are a positive safeguard for air hose connections - they help you meet today's safety standards.|
The King Cable must be installed in the extended position (no slack).
|Hose End||Tool End|
|WSR1||1/8"||½" to 1-¼"||20-¼"||325|
|WSR3||3/16"||½" to 1-¼"||28"||675|
|WSR2||1/4"||1-½" to 3"||38"||200|
|Hose End||Hose End|
|WB1||1/8"||½" to 1-¼"||20-¼"||325|
|WB3||3/16"||½" to 1-¼"||28"||675|
|WA2||1/4"||1-½" to 3"||38-¼"||200|
|WSR1C||1/8"||WSR1 with safety clip & lanyard used to lock Air King couplings||325|
|WB1C||1/8"||WB1 with safety clip & lanyard used to lock Air King couplings||325|
|WSR1E||1/8"||WSR1 with stainless steel safety marine eye used to connect safety cable to a bolt on a tool||325|
|WA2B||1/4"||WA2 with bronze / copper ferrule for special environmental conditions||200|
|WB1SS||1/8"||WB1 made with 304 stainless steel cable and springs with bronze / copper ferrules for special environmental conditions||325|
|Standards - 29 CFR, 1915.131 (partial):|
(e) Before use, pneumatic tools shall be secured to the extension hose or whip by some positive means to prevent the tool from becoming accidentally disconnected from the whip.
Standards - 29 CFR, 1926.302 (partial):
(b)(1) Pneumatic power tools shall be secured to the hose or whip by some positive means to prevent the tool from becoming accidentally disconnected.
Standards - 29 CFR, 1926.603 (partial):
(a)(9) Steam hose leading to a steam hammer or jet pipe shall be securely attached to the hammer with an adequate length of at least ¼-inch diameter chain or cable to prevent whipping in the event the joint at the hammer is broken. Air hammer hoses shall be provided with the same protection as required for steam lines.
(a)(10) Safety chains, or equivalent means, shall be provided for each hose connection to prevent the line from thrashing around in case the coupling becomes disconnected.
|Toll Free-800-940-4673||E-Mail - The Post Office|
|COPYRIGHT © 1998-2004 TAMPA RUBBER & GASKET CO., INC.|